Parkside Disc Sander PTSG 140 C2

Tellerschleifgerät / Disc Sander / Ponceuse à disque PTSG 140 C2

IAN: 327279

Features
Disc Sander PTSG 140 C2
For precise working of soft and hard wood
Ideal for clean edges, curves or mitre joints in all angles
Low-vibration, quiet-running motor with variable sanding speed
Sanding pad with hook & loop fixing
Sanding plate angle can be adjusted
Slidable parallel stop with freely adjustable angle
Can be installed vertically or horizontally (attached with a clamp)
Connection to external dust extraction including removable adaptor

Scope of delivery
Unpack the device and check for completeness. Dispose of the packaging material
properly.

  • Disc sanding device
  • Sanding disc
  • Screw clamp
  • Angle stop
  • 6 x sanding paper + carrier film
  • 2x granulation 80
  • 2x granulation 150
  • 2x granulation 240
  • Angle adapter and adapter for external dust extraction
  • Hexagon socket wrench
  • Operating instructions
  • Description of functions
    Please refer to the descriptions below for
    information about the operating devices.
  • Overview
    1 Sanding disc
    2 Speed regulator
    3 On/off switch
    4 Receptor for screw clamp
    5 Mains plug
    6 Angle scale
    7 Screw for angle locking
    8 Washer
    9 Screw for fixing sanding table
    10 Sanding table holder
    11 Sanding table
    12 Slot for angle stop
    13 Angle stop
    13a Angle stop rail
    13b Angle stop screw
    14 Angle adapter for external dust
    extraction
    15 Adapter for external dust
    extraction
    16 Screw clamp
    17 Hexagon socket wrench
    18 Sanding paper
    19 Knurled nut
  • Technical Data
    Disc sander ……………. PTSG 140 C2
    Rated input voltage ……….230 V~, 50 Hz
    Power input ………….140 W (S2 15 min)*
    Idling speed (n0
    ) …………..max. 3600 min-1
    Safety class ……………………………….II
    Protection category………………………IPX0
    Weight ………………………………… 2,4 kg
    Sanding disc diameter …………….125 mm
    Sound pressure level
    (LpA) ……………….63,2 dB(A); KpA= 3 dB
    Sound power level (LWA)
    measured ………. 76,2 dB(A); KWA= 3 dB
  • After continuous operation of 15 minutes the
    drill stops until the device temperature deviates by less than 2 K (2 °C) from the room
    temperature.

Leave a Reply

Your email address will not be published.